first up is the turbo set up. all you need to turbo your aircooled dub.
It comes with the turbo exhaust up-pipes and discharge pipe,hunderbird header which this bolts to, boost pipe, samco joiners,intercooler, rebuilt rejetted solex 32dis boost sensitive carburettor, spacer for carb, low milage t2 turbocharger with high temp coated exhaust housing (.35a/r ex, .48 a/r comp), the t-piece and braided oil lines for the turbo and oil pressure sender, Air filter and samco joiner, oil filler/turbo oil drain, rose jointed turbo support, fuel pressure regulator, fuel pressure gauge and fittings, prototype actuator bracket., boost gauge, lamda sensor and gage.
(text taken from jonnyboost thead about the same set up and modded)
With intercooler

without intercooler



just small air/fuel gage!

£950 the lot! jetted for my 1600 but the lamda sensor will help lots with rejetting if bigger engine.
turbo ported heads from above.


£200
engine lid to fit the intercooler if used on ghia


£50

msd kit for turbo set up.
msd 6AL with rmp limiter dial, boost timing master with retard dial,
bullet dizzy, ht leads and 2x msd2 coils.

£750
job lot of splitty front brake parts, backing plates etc,

£40 the lot
lhs splitty arch repair panel (i cut it to short!)

£15
lhs splitty repair panel (again!)

£20
rear drums for 1965 splitty


£30 the pair
type3 nose cone

£15
1965 splitty rear plates

£30 the pair
ALL ITEMS ARE IN CHELTENHAM AND SUBJECT TO POSTAGE COSTS

also a lhs ghia rear wing,


£175

stalk from misc vw?

£10
ingition for splitty (new)

£15
splitty cargo door bump stops (new)

£10
6v fuel gage from splitty, small crack in chome.


£40
also have a deep sump,will get some pics soon,
£30