FDK HOME
WELCOME TO THE FUN DUBBIN KRIMINALS FORUM.............COME ON IN AND SAY HELLO smile

PLEASE REGISTER TO ACCESS THE CHAT FORUM

fdk and www.roastietoastie.com

smile 100% A LITTLE BIT GREENER THAN IT WAS BEFORE smile

You are not connected. Please login or register

Starter motor issues

View previous topic View next topic Go down  Message [Page 1 of 1]

1 Starter motor issues on 15/3/2011, 4:50 pm

substandard

avatar


What's going on here???!



Where's the best place to get a new starter motor?

2 Re: Starter motor issues on 15/3/2011, 4:53 pm

substandard

avatar
I'll have another go at the photos then.... confused

3 Re: Starter motor issues on 15/3/2011, 4:58 pm

substandard

avatar
substandard wrote:



What's going on here???!



Where's the best place to get a new starter motor?



There they are!!

4 Re: Starter motor issues on 15/3/2011, 7:57 pm

oilyT

avatar
The bronze starter suport bush has gone. how bad has the starter / fly wheel warn . you may get away with a new bush and a clean up of the starter gear if its not to bad. smile

5 Re: Starter motor issues on 15/3/2011, 8:14 pm

substandard

avatar
The flywheel didn't look too bad in the flesh but in the pic it looks quite bad. The gear on the motor looks fucked. Does the bush look like there's 1 bush inside another to you? The bush feels loose but I can't get it out..

6 Re: Starter motor issues on 15/3/2011, 8:38 pm

oilyT

avatar
no its just the bronze bush in there. you may get it out by trying to screw a bolt or tap in and pull it out. smile

7 Re: Starter motor issues on 15/3/2011, 9:19 pm

substandard

avatar
Yeah I tried to screw a bolt in but because it's loose, it just span round and wouldn't bite.

8 Re: Starter motor issues on 15/3/2011, 9:31 pm

oilyT

avatar
Ah well its going to be a case of being inventive with whats at hand to prize it out. but you cant damage the hole the bush goes in. could you try and hydrolic it out with grease and a bolt. smile

9 Re: Starter motor issues on 15/3/2011, 9:56 pm

substandard

avatar
oooh yeah! I could turn something on my lathe! Nice one baz!

10 Re: Starter motor issues on 23/3/2011, 6:19 pm

substandard

avatar
Sorted Very Happy

Bush came out with a bolt screwed into it. New bush was a little loose so some centre pops and some bearing glue sorted that. New motor from VW Heritage and it sounds and starts so much better! ACE!!

Sponsored content


View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum