FDK HOME
WELCOME TO THE FUN DUBBIN KRIMINALS FORUM.............COME ON IN AND SAY HELLO smile

PLEASE REGISTER TO ACCESS THE CHAT FORUM

fdk and www.roastietoastie.com

smile 100% A LITTLE BIT GREENER THAN IT WAS BEFORE smile

You are not connected. Please login or register

Solex 34 pict 3

View previous topic View next topic Go down  Message [Page 1 of 1]

1 Solex 34 pict 3 on 20/11/2013, 2:11 pm

EGG

avatar
Hi All
Long time. Hope everyones well.
Just took carb of the bug opened the float chamber up and found brass part and ball bearing in there????
Operation 07 on rebuilt sheet of link below shows the brass part. (just to the left of screwdriver).
http://www.volksworld.com/wp-content/uploads/2012/08/CarbOverhaul.pdf
Is this repairable? or is my carb fucked.
Cheers
Graham

2 Re: Solex 34 pict 3 on 20/11/2013, 3:38 pm

substandard

avatar
ball bearing??

it's not you needle valve falling to pieces is it? do they even have ball bearings?

3 Re: Solex 34 pict 3 on 20/11/2013, 10:38 pm

bugjammin

avatar
Ball bearing???

4 Re: Solex 34 pict 3 on 21/11/2013, 8:22 am

oilyT

avatar
Yep its fucked. i'll be round later with the saw for some body cuts.lol 

post a pic up if you can . if it was the shut off valve falling apart it should of flooded like a bastard.

5 Re: Solex 34 pict 3 on 26/11/2013, 1:08 pm

EGG

avatar
Will try to get a pic up soon.
It ain't the inlet, that is all intact and working as the chamber isn't flooding and it's holding fuel back in inlet pipe when float is up.
I am assuming the ball bearing is suppose to be under the brass 'ferrel'??? could be wrong though (normally i am)

Sponsored content


View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum